You have no items in your shopping cart.
*Fast Shipping *Buy Now and Pay Later
*Authorized Dealer *Safe Purchases
*Outstanding Customer Service A+++
NOTE: This product is currently discontinued/unavailable
The Omni 2.5 Bar MAP Sensor allows for tuning of your turbocharged or supercharged FR-S / BRZ
When you decide to join the boost side. The stock map sensor can not read the boost levels that your ecu needs to appropriately adjust to run at its full potential. The Omni Map sensors is 100% plug and play. No need for additional harnesses or adapters. Installation takes 2 minutes to replace the stock map sensor. The accuracy of this sensor is 99% accurate. Sensor compensates for temperature readings from -40f to 260f thus never needing to retune at different altitudes.
This MAP sensor WILL REQUIRE TUNING.
Omni Power MAP Sensor 2.5 Bar FR-S BRZ
Omni Power USA 2.5 Bar MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip.
Pressure changes are calculated on a true linear 0-5 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows the Omni Power USA 4 Bar MAP sensor to remain a minimum of 99% accurate from 32 degrees F to 180 degrees F through out its range of scale.
With the true linear pressure vs. voltage scale there is never a need to re-tune at different altitudes as with other sensors. Competitors sensors on the market don't have true linear scaling which can cause your engine to go out of tune with elevation changes, often resulting in idle problems, poor driveability, and catastrophic engine damage.