This item is a high-end aftermarket products for a variety of vehicles. Looking to give the Scion FR-S or Toyota GT-86 owners a functional, yet stylish look to their vehicle, we have developed these carbon fiber brake ducts with LED daytime running lights. The look of the carbon fiber replaces a boring, non-functioning feature of the car with a sleek new, aggressive look. The carbon fiber duct is integrated into the light and features a funnel shape that allows airflow to enter and if desired, use brake ducting to cool the brake calipers. The new DRL features a dual LED so when you activate your turn signal, it switches from a bright white to a flashing orange.
The installation is very simple tapping into the existing marker light and running a switch power wire so you get to have true daytime running lights. These kits are sold as a pair of left and right lights and include the power boxes with wiring. Agency Power does offer a limited lifetime warranty on products. The DRL kits carry a 90 warranty against LED failure.
How to Install Agency Power Carbon Brake Duct | LED DRL Kit
Step 1 – Open the box and inspect the package. Make sure you have the proper quantity of items, there is no damage, and you have the proper tools to install. We happen to have the car on the lift but you can do this on the ground as well.
Step 2 – using a plastic pry tool for body work, gently slide it on the inside of the plastic housing to pop it out of the bumper clips.
Step 3 – Now that the black trim piece is off, you have to remove the factory marker light. To do this, remove some of the clips from the inner wheel well and reach through the back of the bumper to unplug and unmount the light.
Step 4 – Since the kit uses a simple power and ground, connect the light to a battery terminal and test to see if the LED lights power up. You should be able to see both the bright white LED and orange turn signal light.
Step 5 – Now that you have tested your lights, its time to install them. You will want to find an ignition power on contact. This is so the DRL LED only go on when the ignition of the car is on. Typically there are several of these in the fuse box. You may need to extend the wiring depending on how you route it. Using the factory marker light plug, you will need to use a T clamp (or cut and solder) to tap in 1 positive and 1 negative wire. The blue wire (not shown) is what you run to switch power.
Step 6 – With the wiring and module in place, you can then plug the 4 pin male and female connectors together and push the new light in place. Since the light uses the existing tab holes, it will slide into place.
Toyota GT86 - 2013+
SCION FR-S -ALL